LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 ((On-Board-Charging Module (OBCM) - Electrical Diagnostics - 500 - Electric)) >> DTC Troubleshooting >> P1CDC-Low-HEV Wake Up Output Control 1 Circuit Fault-OBCM Ready Wake Up Line >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
OBCM WAKE-UP SIGNAL CIRCUIT OPEN/HIGH RESISTANCE
GROUND SIGNAL CIRCUIT OPEN/HIGH RESISTANCE
OBCM WAKE-UP SIGNAL CIRCUIT SHORTED TO GROUND
ELECTRIC VEHICLE CONTROL UNIT (EVCU)
ON-BOARD CHARGING MODULE (OBCM)
WARNING:

On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.

Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE to perform the High Voltage Power Down procedure.

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.