Section 33 (Audio/Video/Entertainment/Connectivity (Service Information) 500 - Electric): Radio: Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

While installing the radio (1), connect the electrical connectors.
Install and tighten the four radio to instrument panel screws (2).

Courtesy of CHRYSLER GROUP, LLC
Position the radio bezel (1) onto the instrument panel.
Install and tighten the four radio bezel to instrument panel screws.
Connect the 12-volt negative battery cable.
Power up the high-voltage system. Refer to HIGH-VOLTAGE POWER UP .

NOTE:

The radio must be programmed after a radio replacement. Refer to MODULE, RADIO RECEIVER, MODULE PROGRAMMING .

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.