Module, Radio Antenna: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Disconnect the 12-volt negative battery cable.
- Power down the high-voltage system. Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE .
- Remove the passenger side A-pillar trim. Refer to PANEL, A-PILLAR TRIM, REMOVAL
.
- Disconnect the antenna module electrical connector (1).
- Disconnect the antenna module antenna connector (2).
- Remove the antenna module retainer (1) and remove the antenna module (2).