LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Audio/Video/Entertainment/Connectivity (Service Information) 500 - Electric) >> Module, Radio Antenna >> Installation

Module, Radio Antenna: Installation

WARNING: This page is about a different variant/trim than selected.
GC0153400Courtesy of CHRYSLER GROUP, LLC
  1. Install and tighten the antenna module (2) and retainer (1). Tighten the retainer to 2 N.m (18 in. lbs.).
    GC0153401Courtesy of CHRYSLER GROUP, LLC
  2. Connect the antenna module electrical connector (1).
  3. Connect the antenna module antenna connector (2).
    GC0153221Courtesy of CHRYSLER GROUP, LLC
  4. Reinstall the passenger side A-pillar trim. Refer to PANEL, A-PILLAR TRIM, INSTALLATION .
  5. Connect the 12-volt negative battery cable.
  6. Power up the high-voltage system. Refer to HIGH-VOLTAGE POWER UP .
scientia non olet · About LEMON Manuals