Section 33 (Audio/Video/Entertainment/Connectivity (Service Information) 500 - Electric): Amplifier: Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

Connect the amplifier electrical connectors (2).
Position the amplifier (3) to the mounting bracket (4) and install the retainers (1).

Courtesy of CHRYSLER GROUP, LLC
Install the amplifier trim cover (1) to the amplifier mounting bracket (2).
Connect the 12-volt negative battery cable.
Power up the high-voltage system. Refer to HIGH-VOLTAGE POWER UP .

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.