LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Base Brakes (Service Information) - 500 - Electric) >> Hydraulic/Mechanical >> Pads, Brake, Rear >> Removal

Pads, Brake, Rear: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

Before proceeding, refer to CAUTION  and WARNING .

  1. Raise and support the vehicle. Refer to HOISTING .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
    GC0176780Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.

  3. While holding the slide pins stationary, remove the disc brake caliper guide pin bolts (3).
  4. Remove the caliper from the caliper mounting bracket. Hang the caliper using wire or a bungee cord.
  5. Remove the inboard brake pad from the caliper adapter bracket.
  6. Remove the outboard brake pad from the caliper adapter bracket by prying the brake pad outward until it clears the bracket and then remove the pad from the vehicle.
scientia non olet · About LEMON Manuals