Master Cylinder, Brake: Disassembly
WARNING: This page is about a different variant/trim than selected.
CAUTION:
When removing the fluid reservoir (1) from the master cylinder, do not attempt to pry it off using any type of tool. This can damage the fluid reservoir or master cylinder housing.
- Clean the master cylinder housing and brake fluid reservoir. Use only Mopar® Brake Parts Cleaner or equivalent.
- Remove the brake fluid reservoir cap. Using a syringe or equivalent type tool, empty as much brake fluid as possible from the reservoir.
- Remove the brake fluid level switch (2) from the reservoir (1).
- Remove the pin (3) fastening the fluid reservoir (1) to the master cylinder housing (4).
- Pull the reservoir (1) straight up and remove it from the grommet seals in master cylinder housing (2).
- Remove the vacuum seal (2) from the master cylinder mounting flange (1).