Arm, Wiper: Removal: Front
WARNING: This page is about a different variant/trim than selected.
- Unsnap the right end of the wiper pivot cover (1) from the cowl plenum cover/grille panel.
- Unhook the left end of the wiper pivot cover from the cowl plenum cover/grille panel and remove.
- Lift the wiper arm to its over-center position to hold the wiper blade off of the glass and relieve the spring tension on the wiper arm to pivot shaft connection.
- Carefully pry the plastic nut cap (1) off of the pivot end of the wiper arm.
- Remove the nut (2) that secures the wiper arm (3) to the wiper pivot shaft.
- If necessary, use a suitable battery terminal puller (3) to disengage the wiper arm (1) from the wiper pivot shaft (2).
- Remove the wiper arm pivot end from the wiper pivot shaft.