Adaptive Load Limiter

WARNING: This page is about a different variant/trim than selected.

An adaptive load-limiting device is integral to the front passenger seat belt retractor to supplement the anchor buckle and retractor tensioners. The adaptive load limiter is controlled by the Occupant Restraint Controller (ORC). The front passenger retractor has a two pyrotechnic initiators, one for the adaptive load limiter and one for the tensioner. The adaptive load limiter initiator is connected to the vehicle electrical system through a dedicated take out of the body wire harness by a keyed and latching yellow molded plastic connector insulator to ensure a secure connection.

The adaptive load limiter cannot be repaired and, if ineffective or damaged, the entire front seat belt and retractor unit must be replaced. If the front airbags have been deployed, the adaptive load limiter has also been deployed. The adaptive load limiter is not intended for reuse and must be replaced following any front airbag deployment. Refer to RETRACTOR, SEAT BELT, REMOVAL .