Sensor, Seat Track Position: Removal
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the Intelligent Battery Sensor (IBS)/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Perform the 12-Volt Power Down procedure. Refer to 12-VOLT POWER DOWN .
- Reach under the front seat cushion to access the Seat Track Position Sensor (STPS) (2) on a bracket located on the inboard side near the rear of the upper outboard seat track (3).
- Using a small screwdriver, hold the latch feature (4) depressed while sliding the connector end of the STPS off of the bracket.
- Disconnect the seat wire harness connector (1) from the STPS connector receptacle.
- Remove the STPS from under the front seat.