Mirror, Rearview: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12-volt battery cable.
- Using a small pry tool, remove the cover (2) located on the rear of the mirror.
- Remove the harness cover (1).
- Disconnect the harness (1) from the rear view mirror (2).
- Disengage the tab that secures the rear view mirror (2) to the support bracket/button on the inside of the windshield glass.
- Slide the rear view mirror upward to remove.