LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Body - Interior & Exterior - 500 - Electric) >> Instrument Panel >> Glove Box, Instrument Panel >> Installation

Glove Box, Instrument Panel: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152881Courtesy of CHRYSLER GROUP, LLC
  1. Position the glove box module (4) near the instrument panel cover and if equipped, connect any wiring harnesses.
  2. Install the three screws (1) located on the top edge of the glove box module (4).
  3. Install the bolt (2) located in the glove box cavity. Tighten the bolt securely.
  4. Close the glove box door (3) and install the two screws securing the module to the instrument panel cover located on the bottom front edge of glove box module (4).
    GC0152929Courtesy of CHRYSLER GROUP, LLC
  5. Install the center trim bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
  6. Position and align the instrument panel closeout panel (2).
  7. Install the instrument panel closeout fasteners (1).
scientia non olet · About LEMON Manuals