Relay, Horn: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Perform the 12-Volt Power Down procedure. Refer to 12-VOLT POWER DOWN .
- Remove the cover from the Power Distribution Center (PDC) (1) located on the left side of the engine compartment outboard of the battery.
- Refer to the fuse and relay layout map on the underside of the PDC cover for horn relay identification and cavity location.
- Remove the horn relay by grasping it firmly and pulling it straight out from the cavity within the PDC.