LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Front Suspension & Wheel Alignment - 500 - Electric) >> Front >> Link, Stabilizer Bar >> Installation

Link, Stabilizer Bar: Installation

WARNING: This page is about a different variant/trim than selected.
GC0157948Courtesy of CHRYSLER GROUP, LLC
  1. Position each end of the stabilizer link (1) into the strut and stabilizer bar mounting locations then install the nuts.
  2. Holding each end of stabilizer link tighten the nuts (2, 3) to proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  3. Install the tire and wheel assembly and tighten to specifications. Refer to INSTALLATION .
  4. Lower the vehicle and remove supports.
scientia non olet · About LEMON Manuals