LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Antilock Brake System (Abs) (Service Information) 500 - Electric) >> Electrical >> Sensor, Dynamics >> Removal

Sensor, Dynamics: Removal

WARNING: This page is about a different variant/trim than selected.
GC0152732Courtesy of CHRYSLER GROUP, LLC
WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

  1. On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to 12-VOLT POWER DOWN .
  2. Disconnect and isolate the battery negative cable from the battery post.
  3. Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL .
  4. Disconnect the wiring harness connector (1) at the dynamics sensor (2).
  5. Remove the two bolts (3) mounting the dynamics sensor to the floor pan tunnel.
  6. Remove the dynamics sensor (2).
scientia non olet · About LEMON Manuals