LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Distribution >> Motor, Blower >> Installation

Motor, Blower: Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:

Manual Temperature Control (MTC) shown in the illustration. Automatic Temperature Control (ATC) similar.

GC0152528Courtesy of CHRYSLER GROUP, LLC
  1. Position the blower motor (4) into the left side of the HVAC housing (5) and install the three retaining screws (1 and 3). Tighten the screws to 0.8 N.m (7 in. lbs.).
  2. Connect the wire harness connector (2) to the blower motor.
  3. Power up the high-voltage system. Refer to 12 VOLT POWER UP .
  4. Connect the 12-Volt negative battery cable.
scientia non olet · About LEMON Manuals