LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Distribution >> Housing, HVAC >> Installation >> Housing-Air Inlet

Housing-Air Inlet

WARNING: This page is about a different variant/trim than selected.
NOTE:

If the foam seal on the inlet housing is deformed or damaged, the seal must be replaced.

GC0152573Courtesy of CHRYSLER GROUP, LLC
  1. Position the air inlet housing (2) onto the HVAC housing (5).
  2. Install the three screws (1 and 3) that secure the air inlet housing to the HVAC housing. Tighten the screws to 0.8 N.m (7 in. lbs.).
  3. Connect the wire harness connector (6) to the recirculation door actuator (4).
  4. Install the HVAC housing assembly. Refer to HOUSING, HVAC, INSTALLATION .
scientia non olet · About LEMON Manuals