LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Controls >> Sensor, Temperature, Air Outlet >> Removal >> Notes

Sensor, Temperature, Air Outlet: Removal: Notes

WARNING: This page is about a different variant/trim than selected.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE:

The Automatic Temperature Control (ATC) heating and A/C system uses two air outlet temperature sensors, that are mounted in the right side of the HVAC housing. One is for the instrument panel outlets and the other for the floor outlets.

scientia non olet · About LEMON Manuals