LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 ((Power Inverter Module (PIM) - Electrical Diagnostics - 500 - Electric)) >> DTC Troubleshooting >> P167B-00-Controlled System Shutdown >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
VEHICLE IMPACT SIGNAL RECEIVED BY THE POWER INVERTER MODULE (PIM) FROM THE OCCUPANT RESTRAINT CONTROLLER (ORC)
LOSS OF CAN MESSAGE
WARNING:

On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.

Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE to perform the High Voltage Power Down procedure.

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.  Refer to PIM PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  .

scientia non olet · About LEMON Manuals