LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 ((Electronic Air Compressor (EAC) Module - Electrical Diagnostics - 500 - Electric)) >> DTC Troubleshooting >> B11E6-19-Electronic Air Compressor (EAC)-OVERCURRENT >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
HIGH VOLTAGE CABLE CONNECTIONS
ELECTRIC A/C COMPRESSOR (EAC)
WARNING:

On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.

NOTE:

The EAC cannot be repaired and must be replaced if found inoperative or damaged. If an internal failure of the EAC has occurred, The A/C Condenser must also be replaced.

Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE to perform the High Voltage Power Down procedure.

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. 

scientia non olet · About LEMON Manuals