Spindle, Rear: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
The spindle bolts have fastener adhesive on them and are required to be replaced with new bolts every time they are removed.
- Place the rear spindle in position and install four NEW bolts (1) securing the spindle to the axle. Tighten the mounting bolts to 125 N.m (92 ft. lbs.).
- Tighten the mounting bolts to 125 N.m (92 ft. lbs.).
- On vehicles equipped with antilock brakes, install the wheel speed sensor head in the spindle assembly. Install and tighten the mounting screw (2) to 7 N.m (62 in. lbs.).
- Slide the hub and bearing (4) onto the spindle (5).
- Install a NEW hub nut (1) and washer (2) on the spindle and tighten to 280 N.m (207 ft. lbs.).
- Install the brake rotor (3) and caliper assembly (6). Install and tighten the caliper adapter mounting bolts (7) to 57 N.m (42 ft. lbs.). Refer to ROTOR, BRAKE, INSTALLATION
.
- Install the hub and bearing dust cap (2).
- Install rotor mounting pins (1) and tighten to 12 N.m (106 in. lbs.).
- Install tire and wheel assembly. Refer to INSTALLATION .
- Lower the vehicle.
- Pump the brake pedal several times to ensure the vehicle has a firm brake pedal before moving the vehicle.