LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Rear Suspension - 500 - Electric) >> Hub And Bearing >> Installation

Hub And Bearing: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152831Courtesy of CHRYSLER GROUP, LLC
  1. Slide the hub and bearing (4) onto the spindle (5).
  2. Install a washer (2) and a NEW hub nut (1) on the spindle. Tighten the nut to 280 N.m (207 ft. lbs.).
  3. Install the brake rotor (3) and caliper assembly (6). Install and tighten the caliper adapter mounting bolts (7) to 57 N.m (42 ft. lbs.). Refer to ROTOR, BRAKE, INSTALLATION .
    GC0152557Courtesy of CHRYSLER GROUP, LLC
  4. Install the hub and bearing dust cap (2).
  5. Install rotor mounting pins (1) and tighten to 12 N.m (106 in. lbs.).
    GC0152555Courtesy of CHRYSLER GROUP, LLC
  6. Install tire and wheel assembly. Refer to INSTALLATION .
  7. Lower the vehicle.
  8. Pump the brake pedal several times to ensure the vehicle has a firm brake pedal before moving the vehicle.
scientia non olet · About LEMON Manuals