LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Trekking >> Repair and Diagnosis >> Electrical >> Gauges >> Body - Interior & Exterior - 500L >> Seats, Front >> Seat Back, Front >> Assembly

Seat Back, Front: Assembly

GC0153149Courtesy of CHRYSLER GROUP, LLC
  1. If necessary, install the air bag onto the seat back frame. Refer to AIR BAG, SEAT, INSTALLATION .
  2. If necessary, install a new heated seat pad onto the seat back cushion. Refer to PAD, HEATER, INSTALLATION .
  3. Position the seat back cover (1) onto the seat back cushion (3) and attach new hog rings (2).
    GC0158661Courtesy of CHRYSLER GROUP, LLC
  4. Fold the seat back cover (2) completely over to the back of the seat back cushion (1).
  5. Install the seat back cover and cushion onto the seat back frame.
    GC0099132Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Typical front seat back and head restraint sleeves shown.

  6. Install the headrest sleeves (2) by aligning and pushing down on the sleeves.
    GC0158745Courtesy of CHRYSLER GROUP, LLC
  7. Fasten the lower J-channel (3) on bottom of seat cover (2).
  8. Secure the zippers (1) on both sides of the seat back cover (2).
  9. Tuck the zipper ends up into the seat cover.
    GC0159097Courtesy of CHRYSLER GROUP, LLC
  10. Position the head restraint (1) to the seat back.
  11. Press the tabs on the head restraint sleeves (2).
  12. While pressing the tabs (2), push the head restraint (1) straight downward.
scientia non olet · About LEMON Manuals