Panel, Trim, Liftgate: Installation
- Position the upper liftgate trim panel (1) to the liftgate.
- Align the upper liftgate trim panel (1) retainers and engage fully.
- Insert the fastener (3) and the spacer (1) and tighten the fastener (3) securely.
- Raise the rear shelf panel and insert the support cable (2) onto the fastener (3).
- Repeat on the opposite side.
- Position the lower liftgate trim panel (1) to the liftgate.
- Align the lower liftgate trim panel (1) retainers and engage fully.
- Install the fastener under the (1) located at the liftgate pull handle (2) and tighten the fastener securely.
- Install the fastener cover (1).
- Close the liftgate.