DECKLID/Hatch/Liftgate/Tailgate/Swing Gate: Hinge: Removal

Courtesy of CHRYSLER GROUP, LLC

NOTE:

It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.

NOTE:

A suitable body sealant should be used when removing or moving the hinges.

Remove the rear shelf panel (2). Refer to PANEL, REAR SHELF, REMOVAL .
Remove the C-pillar trims. Refer to PANEL, C-PILLAR TRIM, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the liftgate opening weatherstrip (1) along the perimeter of the headliner (2).
With the use of a trim remover (special tool #C-4829A, Remover, Trim) or equivalent, remove the two push pin fasteners (3) from the headliner.
Lower the rear of the headliner (2).

Courtesy of CHRYSLER GROUP, LLC
Support the liftgate, with the use of a suitable lifting device.
Disconnect the liftgate support cylinders (2) from the liftgate side (1). Refer to PROP, GAS, REMOVAL .
Apply 2-3 layers of masking tape along the rear roof edge to protect finish on the liftgate spoiler.

Courtesy of CHRYSLER GROUP, LLC
Using a china maker/grease pen or equivalent, make reference marks where the hinge is mounted to the liftgate and to the header panel.
Place a block under the lift gate and remove the nuts (3) from the hinge (1) located on the body.
Remove the fasteners (2) securing the hinge to the liftgate.
Remove the fastener (3) securing the hinge to the header panel.
Remove the hinge (1) from the vehicle.