Stationary Glass: Windshield: Removal

Courtesy of CHRYSLER GROUP, LLC

Before proceeding with the following repair procedure, review all warnings and cautions. Refer to STATIONARY GLASS, WARNING .
Remove the rear view mirror. Refer to MIRROR, REARVIEW, REMOVAL .
Disconnect the humidity sensor wiring connector, if so equipped.
Remove the cowl grille. Refer to COVER, COWL PANEL, REMOVAL .
If equipped, disconnect the heated windshield wiring connectors and with the use of masking tape, secure the connectors safely away from the edge of the windshield.
Using an assistant and a wire-type windshield cut-out tool (1, 3 and 4), cut and separate the urethane adhesive (2) securing the windshield to the windshield fence.

Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Be careful not to damage painted surfaces when removing moldings or cutting urethane around the windshield.
Using appropriate tools, carefully remove the windshield (1) from the vehicle.