LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Trekking >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Body - Interior & Exterior - 500L >> Seats, Front >> Seat Back, Front >> Removal

Seat Back, Front: Removal

NOTE:

Before proceeding with the following procedure, review all Warnings and Cautions. Refer to WARNING  .

GC0158842Courtesy of CHRYSLER GROUP, LLC
NOTE:

Passenger seat shown. Driver seat similar.

  1. Remove the front seat being serviced and place it on a workbench. Refer to REMOVAL  .
  2. On the outboard side cover, using a small flat bladed tool or equivalent, remove the fastener covers from the recliner lever (1) and height adjuster lever (2).
  3. Remove the fastener (5) from the recliner lever (1).
  4. Remove the fastener (3) from the height adjuster lever (2).
  5. Remove the recliner lever (1) and the height adjuster lever (2).
  6. Remove the fastener from the rear of the side cover.
    GC0158839Courtesy of CHRYSLER GROUP, LLC
  7. On the front inner of the side cover (1), release the side cover clip (2) from the retainer the tab, with the use of a small flat bladed tool (3).
  8. Move the outboard side cover up and forward, releasing it from the seat.
  9. Disconnect the wiring connector from the heated seat switch, if so equipped.
    GC0158968Courtesy of CHRYSLER GROUP, LLC
  10. On the inboard side cover (1), using a small flat bladed tool or equivalent, remove the fastener cover from the side cover.
  11. Remove the fasteners (2) from the inboard side cover.
  12. Remove the fasteners (3) from the rear of the inboard side cover.
  13. Move the inboard side cover (1) up and forward, releasing it from the seat.
    GC0158599Courtesy of CHRYSLER GROUP, LLC
  14. From the bottom of the seat, disconnect the occupant detection sensor wiring connector (2).
  15. Disconnect the seat track position sensor wiring connector (3).
  16. Unfasten the seat wiring harness routing clips (1).
    GC0158788Courtesy of CHRYSLER GROUP, LLC
  17. Disconnect the seat back wiring guide (1).
  18. Unfasten the seat wiring harness routing clips (2).
    GC0158625Courtesy of CHRYSLER GROUP, LLC
  19. Remove the seat belt buckle (3) fastener.
  20. Remove the fasteners (2) from both sides of the seat back (1).
  21. Remove the seat back (1) from the seat cushion.
scientia non olet · About LEMON Manuals