Glove Box Module

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL .
Remove the instrument cluster bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the radio and radio controls. Refer to RADIO, REMOVAL .
Remove the two upper fasteners (1) from the HVAC control bezel.

Courtesy of CHRYSLER GROUP, LLC
Remove the lower fastener (2).
Pull rearward on the bezel (1) to release the inner retainers.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wiring connectors from the multi media port (1).
Remove the HVAC control bezel (2) from the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Remove the instrument panel end cap. Refer to CAP, INSTRUMENT PANEL END, REMOVAL .
Remove the lower instrument panel bezel (2). Refer to BEZEL, INSTRUMENT PANEL, HEATING AND A/C, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) from the glove box assembly (2).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the glove box light switch (3) wiring connector.
Rotate the glove box assembly (1) rearward and downwards until it is released from the crossmember (2).
Remove the glove box assembly (1).