LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Trekking >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System (Service Information) - 500L >> Linkage, Wiper Arm >> Removal

Linkage, Wiper Arm: Removal

GC0152982Courtesy of CHRYSLER GROUP, LLC
NOTE:

The front wiper linkage module includes the front wiper motor.

  1. Disconnect and isolate the negative battery cable.
  2. Remove both front wiper arms from the wiper pivots. Refer to ARM, WIPER, REMOVAL .
  3. Remove the cowl plenum cover/grille panel from over the front wiper linkage module. Refer to COVER, COWL PANEL, REMOVAL .
  4. Remove the two screws (3) that secure the module bracket to the cowl plenum.
  5. Disengage the knob-like rubber insulator from the hole in the rearward wall of the cowl plenum.
  6. Disconnect the wire harness connector (2) from the connector receptacle for the front wiper motor.
  7. Disengage the wire harness retainer (1) from the linkage module bracket.
  8. Remove the front wiper linkage module from the cowl plenum as a unit.
scientia non olet · About LEMON Manuals