LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Trekking >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System (Service Information) - 500L >> Linkage, Wiper Arm >> Installation

Linkage, Wiper Arm: Installation

GC0152982Courtesy of CHRYSLER GROUP, LLC
NOTE:

The front wiper linkage module includes the front wiper motor.

  1. Position the front wiper linkage module into the cowl plenum as a unit.
  2. Engage the wire harness retainer (1) with the linkage module bracket.
  3. Connect the wire harness connector (2) to the connector receptacle for the front wiper motor.
  4. Engage the knob-like rubber insulator into the hole in the rearward wall of the cowl plenum.
  5. Install and tighten the left screw (3) that secures the module bracket to the cowl plenum, followed by the right screw. Tighten the screws to 9 Nm (80 lbf-in).
  6. Install the cowl plenum cover/grille panel over the front wiper linkage module. Refer to COVER, COWL PANEL, INSTALLATION .
    NOTE:

    Be certain to turn the ignition switch to the ON position, then turn the front wiper switch ON and OFF again to cycle the wiper motor and linkage to their natural park position before installing the front wiper arms onto the wiper pivots.

  7. Install both front wiper arms onto the wiper pivots. Refer to ARM, WIPER, INSTALLATION .
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals