LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Pop >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.4L Turbo Engine (Service Information) - 500L >> Valve Timing >> Sprocket(S), Timing Belt And Chain >> Removal

Sprocket(S), Timing Belt And Chain: Removal

  1. Disconnect and isolate the negative battery cable.
  2. Remove the timing belt. Refer to BELT, TIMING, REMOVAL .
    GC0152674Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    When the timing belt is removed and the cylinder head is still installed, DO NOT rotate the camshaft or crankshaft without first locating the proper crankshaft position. Failure to do so will result in valve or piston damage.

  3. If required, remove the crankshaft sprocket (4):
    • Install the (special tool #10307, Holder, Crankshaft Sprocket) (1) with three bolts (3) tightened to 25 N.m (15 ft. lbs.).
    • Remove the bolt (2) and the crankshaft sprocket (4).
    • Discard the bolt (2).
    GC0152635Courtesy of CHRYSLER GROUP, LLC
  4. Lower the vehicle.
  5. If required, use (special tool #6847, Holder, Camshaft Sprocket) (2) and remove the bolt (1) and the camshaft sprocket (3).
scientia non olet · About LEMON Manuals