LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Pop >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.4L Turbo Engine (Service Information) - 500L >> Cylinder Head >> Seal(S), Valve Guide >> Installation

Seal(S), Valve Guide: Installation

NOTE:

Reassemble the valves into their original locations. If the valves or valve seats have been refinished, verify that the valve stem tip height is within specification. Refer to TECHNICAL SPECIFICATIONS .

  1. If removed, install the valve(s). Refer to VALVES, INTAKE AND EXHAUST, INSTALLATION .
    NOTE:

    Valve spring seats are integral to the stem seal and are common Intake and exhaust.

  2. If removed, install the spring seat over the valve guide.
  3. Apply engine oil to the lip of the valve guide seal (3). Install the valve guide seal (3) over the valve stem. Using an appropriate driver (1), push the seal firmly and squarely over the valve guide. Do Not Force  the seal against the top of guide.
    NOTE:

    Make sure that the garter spring is intact around the top of the valve guide seal.

    NOTE:

    If the valve springs are being reused, reassemble them into their original locations. Intake and exhaust springs are unique.

  4. Install the valve spring(s). Refer to SPRING(S), VALVE, INSTALLATION .
scientia non olet · About LEMON Manuals