LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500L Pop >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Bumpers - 500L >> Bumpers >> Fascia, Front >> Installation

Fascia, Front: Installation

GC0158700Courtesy of CHRYSLER GROUP, LLC
  1. Position the front fascia (2) to the vehicle.
  2. Install the front fascia fasteners (1) under the hood area.
  3. Align and position the front fascia (2) to the fender retaining tabs.
  4. Push in on the front fascia sides at the fender to engage the retaining tabs.
    GC0158659Courtesy of CHRYSLER GROUP, LLC
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Connect the side marker lamps wiring connector.
  7. Align the side marker access panel (2) and install the fasteners (1).
  8. If so equipped, connect the fog lamp wiring connector.
  9. Align the fog light access panel (4) and install the fasteners (3).
  10. Repeat on the opposite side.
    GC0158694Courtesy of CHRYSLER GROUP, LLC
  11. Install the front fascia to fender fastener (1) and tighten securely.
  12. Install the wheelhouse splash shield fasteners (2) and tighten securely.
  13. Repeat on the opposite side.
    GC0159081Courtesy of CHRYSLER GROUP, LLC
  14. Install the fasteners (1) into the lower fascia (2).
  15. Lower the vehicle.
  16. Connect the negative battery cable.
scientia non olet · About LEMON Manuals