Seat, Front: Removal
NOTE:
Before proceeding with the following procedure, review all Warnings and Cautions. Refer to WARNING .
NOTE:
Driver side shown, passenger side typical.
- Position the seat fully forward.
- Remove the seat to riser bolts (2) located in the rear area of the front seat (1).
- Position the seat fully rearward.
- Disconnect the negative battery cable.
- With the use of trim stick (special tool #C-4755, Trim Stick) or equivalent, remove the retainers from the seat wiring access cover and remove the cover (3).
- Disconnect the wiring connectors.
- Remove the seat to riser bolts (2) located in the front area of the front seat (1).NOTE:
If equipped with a seat air bag, lift the seat only and only in the area of the head restraint and the front of the seat cushion.
- Remove the seat from the vehicle.