LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Pop, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Body - Interior & Exterior - 500 - Except Electric >> Instrument Panel >> Glove Box, Instrument Panel >> Removal

Glove Box, Instrument Panel: Removal

GC0152929Courtesy of CHRYSLER GROUP, LLC
  1. Remove the instrument panel closeout fasteners (1).
  2. Remove the instrument panel closeout panel (2).
  3. Remove the two screws located on the bottom front edge of glove box module securing the module to the instrument panel cover.
    GC0152881Courtesy of CHRYSLER GROUP, LLC
  4. Remove the center trim bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
  5. Open the glove box door and remove the bolt (2) located in the glove box cavity.
  6. Remove the three screws (1) located on the top edge of the glove box module (4).
  7. Pull the glove box module (4) out and if equipped, disconnect any wiring harnesses.
  8. Remove the glove box module (4).
scientia non olet · About LEMON Manuals