LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Pop, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> (Entertainment TELEMATIC Module (ETM) - Electrical Diagnostics - 500 - Except Electric) >> DTC Troubleshooting >> B1404-12 Front Right Audio Speaker Output Circuit Short To Battery - Base >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    This vehicle has a Front Tweeter wired in parallel with the Front Speaker.

    1. Turn the ignition on and open one of the front doors.
      NOTE:

      A front door must remain open whenever checking or erasing Entertainment Telematic Module (ETM/LTM) DTCs.

    2. With the scan tool, read ETM DTCs and record on the repair order.
    3. Cycle the ignition from on to off, wait five seconds and then back to on.
    4. Turn the ETM on and set the volume to 25.
    5. Adjust the speakers to the front and center.
    6. With the scan tool, read ETM DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK FOR VOLTAGE ON THE (X202) RIGHT FRONT DOOR SPEAKER (+) CIRCUIT 
    1. Turn the ignition off.
    2. Disconnect the ETM C1 harness connector.
    3. Disconnect the Right Front Door Speaker harness connector.
    4. Disconnect the Right Front Tweeter Speaker harness connector.
    5. Turn the ignition on.
    6. Measure the voltage between ground and the (X202) Right Front Speaker (+) circuit at the ETM C1 harness connector.

      Is there any voltage present?

      Yes 

      • Repair the (X202) Right Front Speaker (+) circuit for a short to voltage.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Go To  3
  3. CHECK FOR VOLTAGE ON THE (X292) RIGHT FRONT SPEAKER (-) CIRCUIT 
    1. Measure the voltage between ground and the (X292) Right Front Speaker (-) circuit at the ETM C1 harness connector.

      Is there any voltage present?

      Yes 

      • Repair the (X292) Right Front Speaker (-) circuit for a short to voltage.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Replace the ETM in accordance with the service information. Refer to REMOVAL .
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
scientia non olet · About LEMON Manuals