Diagnostic Test

CHECK FOR AN ACTIVE DTC
NOTE:
This vehicle has a Front Tweeter Speaker wired in parallel with the Front Door Speaker.
1. Turn the ignition on.
2. Using the scan tool, record and erase the Entertainment Telematic Module (ETM/LTM) DTCs.
3. Turn the Radio on.
4. Adjust the speakers to the front and center.
5. Using the scan tool, read the active ETM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK FOR VOLTAGE ON THE (X201) LEFT FRONT SPEAKER (+) CIRCUIT
1. Turn the ignition off.
2. Disconnect the ETM C1 harness connector.
3. Disconnect the Left Front Door Speaker harness connector.
4. Disconnect the Left Tweeter Speaker harness connector.
5. Turn the ignition on.
6. Measure the voltage between ground and the (X201) Left Front Speaker (+) circuit.
  Is there any voltage present?
  
  Yes
  - Repair the (X201) Left Front Speaker (+) circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK FOR VOLTAGE ON THE (X291) LEFT FRONT SPEAKER (-) CIRCUIT
1. Measure the voltage between ground and the (X291) Left Front Speaker (-) circuit.
  Is there any voltage present?
  
  Yes
  - Repair the (X291) Left Front Speaker (-) circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the ETM in accordance with the service information. Refer to REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .