Diagnostic Test
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on and open one of the front doors.NOTE:
A front door must remain open whenever checking or erasing Entertainment Telematic Module (ETM/LTM) DTCs.
- With the scan tool, read ETM DTCs and record on the repair order.
- With the scan tool, erase DTCs.
- Cycle the ignition from on to off, wait five seconds and then back to on.
- Turn the radio on and set the volume to 25.
- Adjust the speakers to the rear and center.
- With the scan tool, read ETM DTCs.
Did the DTC return?
Yes
- Go To 2
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Turn the ignition on and open one of the front doors.
- CHECK FOR VOLTAGE ON THE (X205) LEFT REAR SPEAKER (+) CIRCUIT
- Turn the ignition off.
- Disconnect the ETM C1 harness connector.
- Disconnect the Left Rear Speaker harness connector from the Left Rear Speaker.
- Turn the ignition on.
- Measure the voltage between ground and the (X205) Left Rear Speaker (+) circuit at the ETM C1 harness connector.
Is there any voltage present?
Yes
- Repair the (X205) Left Rear Speaker (+) circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3
- CHECK FOR VOLTAGE ON THE (X295) LEFT REAR SPEAKER (-) CIRCUIT
- Measure the voltage between ground and the (X295) Left Rear Speaker (-) circuit at the ETM C1 harness connector.
Is there any voltage present?
Yes
- Repair the (X295) Left Rear Speaker (-) circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the ETM in accordance with the service information. Refer to REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Measure the voltage between ground and the (X295) Left Rear Speaker (-) circuit at the ETM C1 harness connector.