LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Pop, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control Module (BCM) - DTCS B10AD-19 To U1749-87 - 500 - Except Electric >> DTC Troubleshooting >> B12CB-23 Cruise Control Switch Signal Stuck Low >> Diagnostic Test

Diagnostic Test

CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC) 

  1. Turn the ignition on.
  2. With the scan tool, read DTCs

    Does the scan tool display this DTC as active?

    Yes 

    WARNING:

    Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    WARNING:

    Do not place an intact non-deployed airbag face down on a hard surface, the airbag propels into the air if accidentally deployed. Failure to follow these instructions may result in possible serious or fatal injury.

    NOTE:

    Visually and physically inspect the wiring harness between the Right Steering Wheel Switch (Speed Control Switch) harness connector and the Clockspring harness connector. Repair any damaged wires, connectors, and open/spread terminals. If harness is OK, proceed with test.

    • Replace the Speed Control Switch in accordance with the service information. Refer to REMOVAL .
    • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

    No 

    • Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
scientia non olet · About LEMON Manuals