Diagnostic Test

CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the High Beam Headlamps on.
4. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE HIGH BEAM RELAY
1. Turn the High Beam Headlamps off.
2. Turn the ignition off.
3. Remove the High Beam Relay and substitute it with a known good relay.
4. Turn the ignition on.
5. Turn the High Beam Headlamps on.
6. With the scan tool, read DTCs.
  Does the scan tool display DTC: B1028-19 HIGH BEAMS OVER CURRENT?
  
  Yes
  - Go To 3
  No
  - Replace the High Beam Relay.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (L300) HIGH BEAM RELAY CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Remove the High Beam Relay.
3. Disconnect the BCM C1 harness connector.
4. Turn the ignition on.
5. Measure the voltage between ground and the (L300) High Beam Relay Control circuit.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage in the (L300) High Beam Relay Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the BCM in accordance with the service information. Refer to REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .