DECKLID/Hatch/Liftgate/Tailgate/Swing Gate: Latch: Installation

WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12 volt battery negative cable alone will not power down the 12 volt system. You must perform the 12 volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

Courtesy of CHRYSLER GROUP, LLC

Connect the harness connector (2) to the latch (1).
Position the latch into liftgate access cavity.

Courtesy of CHRYSLER GROUP, LLC
Install the fasteners (1) to the latch. Tighten fasteners to 8 Nm (6 lbf-ft).
Install the liftgate trim panel. Refer to PANEL, TRIM, LIFTGATE, INSTALLATION .
On vehicles equipped with the high voltage system, power up the 12 volt system.
Refer to 12 VOLT POWER UP .
Connect the 12 volt negative battery cable.