LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System - 500 - Except Electric >> Engine >> Fan, Cooling >> Removal

Fan, Cooling: Removal

NOTE:

The cooling fan must be removed from the bottom of the vehicle.

GC0152359Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Drain out enough coolant to bring the level below the pump.
  3. Remove the engine cover and the air intake assembly (1).
    GC0153787Courtesy of CHRYSLER GROUP, LLC
  4. ABARTH ONLY:  Disconnect the two vacuum fittings (4), loosen the clamp (3) at the air to turbocharger inlet tube.
  5. ABARTH ONLY:  Disconnect the fresh air intake hose (2).
  6. ABARTH ONLY:  Remove the air cleaner assembly (1).
    GC0152401Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the cooling fan resistor (1) harness connector at the cooling fan (2).
    GC0152367Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the cooling fan harness connector (3).
    NOTE:

    Do not remove the cooling fan from the lower mounting tabs at this time.

  9. Remove the upper cooling fan (2) mounting bolts (4).
  10. Raise and support the vehicle.
  11. Remove the front bumper fascia. Refer to FASCIA, FRONT, REMOVAL .
    GC0152366Courtesy of CHRYSLER GROUP, LLC
  12. Remove the upper (4) and lower (3) air seals.
  13. Remove the front bumper support beam (1).
  14. Support the radiator and the A/C condenser with a suitable fixture.
    GC0153790Courtesy of CHRYSLER GROUP, LLC
  15. ABARTH ONLY: 

    Disconnect the turbocharger outlet hose (2) at the lower quick connect located behind the cooling fan (3).

    GC0153797Courtesy of CHRYSLER GROUP, LLC
  16. ABARTH ONLY: 

    Disconnect the right intercooler quick connect (1).

    GC0153798Courtesy of CHRYSLER GROUP, LLC
  17. ABARTH ONLY: 

    Disconnect the left intercooler quick connect.

  18. ABARTH ONLY: 

    Remove the bolts that secure the tube to the lower core support and remove the tube assembly. This will allow for clearance when lowering the fan module out of the vehicle.

    GC0152386Courtesy of CHRYSLER GROUP, LLC
  19. Remove the lower radiator support brackets (2).
  20. Use care when positioning the radiator and the A/C condenser aside.
  21. Remove the cooling fan from the lower mounting tabs located on the radiator.
  22. Remove the cooling fan from the vehicle through the bottom of the cooling module assembly.
scientia non olet · About LEMON Manuals