Mount, Motor: Installation: Lower
WARNING: This page is about a different variant/trim than selected.
- Install the clevis bracket to the gearbox.
- Install the three bolts (1).NOTE:
THE CLEVIS BOLTS MUST BE TORQUED IN THE FOLLOWING MANNER.
- Torque the three bolts to 50 Nm (37 lbf-ft).
- Loosen the three bolts 180°.
- Torque the three bolts to 63 Nm (46 lbf-ft).
- Position the lower mount at the frame.
- Install the strut mount bolts (2) and the isolator through bolt (1).
- Tighten the strut mount bolts to 109 Nm (80 lbf-ft).
- Tighten isolator through bolt to 100 Nm (74 lbf-ft).
- Remove the support stand and lower the vehicle.