LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 70 (Ignition System (Service Information) - 1.4L 16-Valve Turbo - 500) >> Relay, Auto Shut Down >> Removal

Relay, Auto Shut Down: Removal

WARNING: This page is about a different variant/trim than selected.

The Automatic Shutdown (ASD) relay is located in the engine compartment within the Power Distribution Center (PDC). Always refer to the label on the PDC cover for relay location.

  1. Remove the PDC cover.
  2. Remove the relay from the PDC.
  3. Check the condition of the relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing the relay.
  4. Check for pin height. Pin height should be the same for all terminals within the PDC connector. Repair if necessary before installing the relay.
scientia non olet · About LEMON Manuals