LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 68 (Body - Interior & Exterior - 500 - Electric) >> Seats >> Handle, Front Recliner >> Adjustments >> Passenger Seat

Passenger Seat

WARNING: This page is about a different variant/trim than selected.
GC0153138Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before proceeding with the following procedure, review all Warnings and Cautions. Refer to WARNING  .

  1. Using (special tool #C-4755, Trim Stick), remove the trim cap (1) from the seat back recliner lever (2).
    GC0153139Courtesy of CHRYSLER GROUP, LLC
  2. Remove the screw (1) and washer (2) that secure the seat back recliner lever (3) to the seat and remove the lever.
  3. Remove the two screws that secure the inboard seat cushion side shield (4) to the seat and remove the side shield.
    GC0153767Courtesy of CHRYSLER GROUP, LLC
  4. Lift the fabric (1) covering the recliner cable.
    GC0153768Courtesy of CHRYSLER GROUP, LLC
  5. Install a tie strap (2) through the hole of the seat recliner lever that secures the cable retaining clip (1). Cut off the excess length from the tie strap.
  6. Attach the cable retaining clip (1) to the seat adjusting lever if disengagement has occurred.
    NOTE:

    Make sure the head of the tie strap is facing outward and does not interfere with lever travel.

    GC0153139Courtesy of CHRYSLER GROUP, LLC
  7. Position the inboard seat cushion side shield (4) to the seat and install the two retaining screws. Tighten the screws securely.
  8. Install the seat back recliner lever (3).
  9. Install the screw (1) and washer (2) that secures the seat back recliner lever. Tighten the screw securely.
    GC0153138Courtesy of CHRYSLER GROUP, LLC
  10. Install the trim cap (1) onto the seat back recliner lever (2).
  11. Install the front seat. Refer to INSTALLATION  .
scientia non olet · About LEMON Manuals