Cover, Cowl Panel: Removal
WARNING: This page is about a different variant/trim than selected.
- Open the hood.
- Remove the cowl screen trim covers (1).
- Remove the wiper arms. Refer to
ARM, WIPER, REMOVAL
.
- Using a small pick tool, remove the three push fasteners (1) from the cowl screen (2).
- Pull up on the cowl screen to disengage the snap retainers.
- Disconnect the washer hose from the nozzle.
- Remove the cowl screen (2).
- Remove the two speed nuts (1). Repeat for the opposite side.
- Remove the five fasteners (1) across the cowl plenum (3).
- Remove the cowl plenum (3).