LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Aw60T Automatic Transmission (Service Information) - 500) >> Seal, Input Shaft >> Removal

Seal, Input Shaft: Removal

WARNING: This page is about a different variant/trim than selected.
GC0153376Courtesy of CHRYSLER GROUP, LLC
  1. Remove the transmission from vehicle. Refer to REMOVAL  .
  2. Remove the torque convertor from the transmission assembly. Refer to REMOVAL  .
  3. Use Seal Remover (special tool #9667, Remover, Seal) and Slide Hammer (special tool #C-3752, Slide Hammers) to remove the oil pump seal (1).
scientia non olet · About LEMON Manuals