Cable, Shift: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
Make sure the rubber grommet in the floor pan is fully seated to prevent water leaking into the passenger compartment.
- Install the shifter cable to the vehicle.
- Install the shifter cable (2) to the retaining clip (1).
- Push the shifter cable grommet (1) through the floor from beneath the vehicle.
- Lower the vehicle.
- Seat the rubber grommet into the floor pan. Ensure that the grommet is fully engaged to the floor pan.
- Install the shifter. Refer to INSTALLATION
.
- Install the shift cable (1) to the bracket (2). Make sure the lock tab (3) on the shift cable is fully seated.
- Connect the shift cable (1) to the transaxle manual valve lever.
- Install the battery tray. Refer to INSTALLATION .
- Adjust the shifter cable. Refer to ADJUSTMENTS .