LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 57 (Frame And Bumpers - 500 - Electric) >> Bumpers >> Reinforcement, Bumper, Front >> Installation

Reinforcement, Bumper, Front: Installation

WARNING: This page is about a different variant/trim than selected.
GC0153091Courtesy of CHRYSLER GROUP, LLC
  1. Position the lower bumper reinforcement (2) to the frame/front end module.
  2. Install the fasteners securing the lower bumper reinforcement (2) to the frame/front end module. Tighten the fasteners to 45 Nm (33 lbf-ft). If necessary, repeat on the opposite side.
  3. Position the upper bumper reinforcement (1) to the frame/front end module.
  4. Install the fasteners securing the upper bumper reinforcement (1) to the frame/front end module. Tighten the fasteners to 45 Nm (33 lbf-ft). If necessary, repeat on the opposite side.
  5. Install the front fascia. Refer to INSTALLATION  .
scientia non olet · About LEMON Manuals