LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Chime/Buzzer/Driver Assist (Service Information) 500 - Electric) >> Module, Park Assist >> Installation

Module, Park Assist: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152722Courtesy of CHRYSLER GROUP, LLC
  1. Position the Park Assist Module (PAM) (4) to the right quarter inner panel near the base of the C-pillar.
  2. Engage the lower mounting tab of the PAM into the stamped pocket (3) in the right quarter inner panel.
  3. Install and tighten the screw (1) that secures the upper mounting tab of the PAM to the right quarter inner panel. Tighten the screw securely.
  4. Reconnect the two (with rear park assist) or three (with front and rear park assist) body wire harness connectors (2) to the PAM connector receptacles.
  5. Reinstall the trim onto the right quarter inner panel. Refer to INSTALLATION .
  6. Perform the 12-Volt Power Up procedure. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals